Hola, colegas.
Me llego este J7 Prime G610F con cuenta FRP, como sabemos este modelo cuenta con un procesador exynos, por lo que la octoplus entre las opciones de reseteo FRP, me da la posibilidad de hacerlo mediante cable UART, que actua sobre el UFS. Ya lo habia hecho antes incluso con un S7 G935W8 con version de Android 7, exitosamente.
Pero cuando intente hacerselo a este J7 miren el log de la caja
Platform: Samsung Android
Selected port: COM129
Selected model: SM-G610F
Operation: Reset FRP - UART EMMC
Searching for UART interface..
COM9
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...
OK
Please connect phone to USB cable..
Searching for a phone. Please wait...
OK
Reading data...
Checking operation...
This version of "sBoot" is not supported, try to downgrade "sBoot"!
Operation was failed!
Performed by 2.7.4 Software version.
Despues de intentar hacer el FRP por otras vias, incluido flashear el sboot.bin y el boot.img de la combination, no consegui ningun resultado.
Reflashee la rom de stock, y casi de casualida di con la solucion al problema.
Decidi flashear solo el sboot.bin, en un intento de degradarlo tal y como decia la caja, y Voila!!! FRP OFF
Aqui el log de la caja
Platform: Samsung Android
Selected port: COM129
Selected model: SM-G610F
Operation: Reset FRP - UART EMMC
Searching for UART interface..
COM9
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...
OK
Please connect phone to USB cable..
Searching for a phone. Please wait...
OK
Reading data...
Checking operation...
OK
Searching for UART interface..
COM9
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (1/4 attempt)..
success
FRP / Reactivation lock is successfully reseted!
Performed by 2.7.4 Software version.
Espero sea de ayuda a los colegas, este metodo ya ln pude usar ademas en un J5 Prime G570M. Saludos
Después de tanto batallar, 2 días probando cosas me funciono de la siguiente forma:
FRP G610F Android 7 con Octopus 2.7.4
1- Flashear el boot ADB G610F.tar 16.9 MB, el telefono lo mata pero delajo así, aunque no salga nada en pantalla.
2- Luego con la Octopus o Z3X ejecutar el Reset FRP para dicho modelo via ADB ya que lo activa, ojo aunque no salga nada en Pantalla.
3- Con el cable RJ-45 de la caja, ejecutar Reset FRP via UART.
4- Por ultimo flashear el AP.
"Listo a Cobrar"
Por Merme
TopCell
Potenciado por Invision Power Board
© Invision Power Services