Frp A Un Pcd 508 Opciones

[denio15]

despues de tanta lucha!!!!
FRP PCD 508
Es importante instalar drivers mtk,luego instalar NCKDONGLE ANDROIDMTK 2.5.6.2
Se van ala pestaña "service" elegimos el modelo MT6735 Y le damos a "Reset frp" luego continue? le damos si
procedemos a conectar el celular... yo intente de todas formas, pero me funciono : celular apagado, con el boton - presionado conectamos el cable usb y empiesa su proceso.
Reinsert phone battery.
Battery must be charged.
Phone must be off with battery inside.
Please insert USB cable now...
Detected : MediaTek PreLoader USB VCOM (Android) (COM32)
Phone detected...Please wait
Sending DA agent, please wait...
BaseBand CPU :MT6735M_S00
BaseBand CPU Secure Version : FF
BaseBand CPU Bootloader Version : 01
----------------------------------------------------
INT RAM: 128 KB SDRAM
EXT RAM: 1 GB DRAM
----------------------------------------------------
EMMC: (57Gb+8192Mb) KSI 0x454838454538
EMMC FW VERSION: 01:00:00:00:00:00:00:00
EMMC CID: 70010045483845 : 000000000000000000
EMMC UA SIZE: 0x1c8000000
BOOT STYLE: EMMC BOOT
FULL LENGTH: 0x1c8c00000 [7.137 GB]
Detecting high speed port, wait......
If driver not installed, install high speed port driver.
If not need high speed port, disable it.
After repeat opperation.
Detecting high speed port, wait......
Detected : MediaTek DA USB VCOM (Android) (COM26)
Checking data....wait!

FORMAT EMMC FLASH : BEGIN: 0x6a00000 - LEN: 0x100000
FRP Reset Done.
Wait untill phone will start charging.
All done.[font="Impact"][/font][/size][size="4"]

Mensaje modificado por denio15 el Feb 13 2019, 12:06 PM